Mainframe, MVS and zOS Discussion

Code: Select all

MARGINS

The MARGINS option specifies which part of each compiler input record contains PL/I statements, and the position of the ANS control character that formats the listing, if the SOURCE and/or INSOURCE options apply. The compiler does not process data that is outside these limits, but it does include it in the source listings. The PL/I source is extracted from the source input records so that the first data byte of a record immediately follows the last data byte of the previous record. For variable records, you must ensure that when you need a blank you explicitly insert it between margins of the records.

                    +- 2 -+     +- 72 -+
                    |     |     |      |
     +- MARGINS --(-+- m -+- , -+-  n -+-+-------+-- ) -+
     |                                   |       |      |
     |                                   +- , c -+      |
>> --+- NOMARGINS --------------------------------------+------><

ABBREVIATION: MAR

m The column number of the leftmost character (first data byte) that is processed by the compiler. It must not exceed 100.

n The column number of the rightmost character (last data byte) that is processed by the compiler. It should be greater than m, but must not exceed 200, except under MVS batch where it must not exceed 100. 

Variable-length records are effectively padded with blanks to give them the maximum record length.

c The column number of the ANS printer control character. It must not exceed 200, except under MVS batch where it must not exceed 100, and it should be outside the values specified for m and n. A value of 0 for c indicates that no ANS control character is present. Only the following control characters can be used:

(blank) Skip one line before printing
      0 Skip two lines before printing
      – Skip three lines before printing
      + No skip before printing
      1 Start new page

Any other character is an error and is replaced by a blank.